Guides and advice

Rubble and skips in a renovation: real volumes, street permit and price

A 7.5 m² partition wall leaves around 1 m³ of rubble. Here is how to remove it, which permit to confirm with your town hall and what it usually costs per m³.

By the Tu Nuevo Piso teamPublished 16 November 202611 min read
Eixample living room being demolished, with partition rubble and bags

Indicative prices · VAT not included. Not a binding offer.

A renovation produces more rubble than almost anyone expects, and it is counted in cubic metres after bulking, not in metres of wall. Knocking down a 7.5 m² partition wall leaves around 1 m³, and that is the starting point for deciding whether bags are enough, whether you need a skip or whether a lorry makes more sense.

The rest of the equation is practical: which permit the town hall requires to leave a skip on the street, who hires it and which paper from the authorised waste carrier you should hold at the end.

Key points

  • A non-structural partition wall 3 m long (7.5 m²) leaves around 1 m³ of rubble, bulking already included.
  • The price list gives rubble removal at 28 €/m³ (functional), 41 €/m³ (mid-range) and 65 €/m³ (high-end), as a guide and without VAT.
  • Bags, skip or lorry are chosen by the building's access and by the volume, not by the hire price.
  • The permit to occupy the public highway depends on your town hall: confirm it before ordering the skip.
  • Always ask in writing who hires the removal and keep the receipt from the authorised waste carrier.

How many m³ of rubble a renovation produces: the partition wall and bulking

Renovation rubble is calculated from what you demolish, multiplied by the bulking factor, which is why broken material takes up much more room than it did in place. A solid partition in the wall is a compact block; broken up in a skip, it leaves gaps between the pieces and takes up considerably more volume.

Hardly anyone does this sum before the works start, and that is where the surprises come from. People think of "four walls" and end up calling for a second skip.

Here is the example with numbers. Take a non-structural partition wall 3 m long by 2.5 m high, that is, 7.5 m². A hollow-brick partition is usually around 7-10 cm thick. In the wall it is a little over half a cubic metre, but once broken out, with its plaster, and loaded into bags or a skip, the volume to be removed comes close to 1 m³.

That is the figure we use in our works scenarios: removing a partition of this size is priced with 1 m³ of rubble, already bulked. If you also lift the strip of floor where the partition stood, or the flooring of a whole room, the volume goes up.

Be careful not to confuse square metres of demolition with cubic metres of waste. What you pay for and what fills the skip is the cubic metres. Hydraulic tile or porcelain stoneware flooring taken up throughout a home weighs and takes up much more than any partition.

In the old buildings of the Eixample and Gràcia, with no lift or with a narrow staircase, we almost always end up deciding the rubble logistics before breaking anything out. What looks like a detail at the end of the job affects how the demolition is organised from day one: where the material goes down, how many times a day and how much fits in each trip.

A full home renovation mixes everything: brick, plaster, tiles, flooring, mortar remains, sometimes wood and fibre cement. Each type is separated or handled differently depending on what the waste carrier asks for. If asbestos turns up during demolition, that material is not mixed with the rest and has its own procedure.

Bags, skip or lorry: how to choose according to the building's access

The choice between bags, skip or lorry is decided by access to the building long before the price. With stairs, no lift and nowhere to park, a skip on the street can be a problem; with a garage or courtyard, it is the most convenient option.

MethodWhen it fitsWhat to check
BagsSmall jobs, a partition wall or a bathroom; buildings with no space for a skipCarried down the stairs by hand; the stairs must be protected and the trips counted
Skip on the streetMid-sized or full renovations with a large volumeYou need somewhere to put it and, depending on the town hall, a permit to occupy the public highway
Lorry with crane or conveyor beltJobs with a lot of volume and difficult accessEach waste carrier and each street has its own conditions; ask before offering it to the client

For small jobs, bags are the sensible choice. A 1 m³ partition does not justify putting a skip at the building's front door. The bags are filled, carried down and loaded onto the waste carrier's lorry in a single visit.

For a full renovation the approach changes. A whole flat stripped of partitions, tiling and flooring produces several skips over the course of the works. In that case it pays to schedule the collections, because a full skip left on the street for three days is a problem with the neighbours and, depending on the case, with the town hall.

And there is one thing that gets forgotten: the staircase. Taking rubble out through a shared entrance obliges you to protect the common areas, and that is done before you start carrying bags down, not when there is already dust on the landing. Who is liable for damage is a conversation to have beforehand with the owners' community.

If the building has no lift, ask how many bags are carried down per trip and how many workers are needed. That labour is paid for. A quote that says "rubble removal" without explaining how it is carried down may be leaving out the most expensive part.

Metal building skip parked next to an old building without a lift in Barcelona
On narrow streets, the skip's position is decided before the demolition starts.

Permit for a skip on the public highway: what is known and what to confirm with your town hall

Leaving a skip on the street usually requires authorisation from the town hall, but the specific conditions change from one municipality to another. We do not have a single rule to cite here, and we are not going to invent one: the thing to do is ask your town hall.

What we can say is what tends to be true in practice. Occupying the public highway is not the same as the works permit. The works licence or the prior notification authorises you to carry out the renovation; the skip on the street is a separate procedure, with its own fee and its own handling, and having the first does not mean having the second.

There are three things worth asking the town hall before ordering the skip:

  • Whether a specific authorisation is needed to occupy the public highway and, if so, what documents they ask for.
  • Whether the skip can go in a parking space or only in certain areas and at certain times.
  • How many days it may stay and whether it must be marked or covered.

In neighbourhoods with narrow streets such as Ciutat Vella or a good part of Gràcia, finding a spot is already half the problem. On some jobs the skip cannot be left in front of the entrance and another solution is agreed with the waste carrier, such as bags and an occasional lorry.

Who applies for the permit? Usually the company that supplies the skip or the one running the works handles it, but do not take it for granted. Your quote should state in writing who applies, who pays the fee and what happens if the town hall refuses or delays it. If the contract does not say, you will end up arguing about it with the works under way.

If your community has its own rules on noise hours or cleaning of common areas, those count too. No municipal permit replaces them.

Authorised waste carrier and receipt: who hires and what to keep

Building rubble cannot be dumped wherever one likes: it is collected by an authorised construction waste carrier, and you must have a receipt for that removal. It is the paper that shows the waste went where it should and not to a patch of waste ground.

We are not going to give you a specific article of a regulation that we have not verified here. What is true in practice is that the waste carrier issues a document for the delivery and that you should hold that paper, not only the renovation company. If there is later an inspection, a complaint from the community or a question from a technician, it is what protects you.

What should be made clear in the contract:

  • Who hires the removal: the renovation company, you directly, or a third party.
  • Which waste carrier it is and that it is authorised, with its name on the document.
  • Which receipt you will get at the end and who hands it to you.

On our jobs the removal is hired within the fixed quote and the waste carrier's receipt should end up in your hands. We do not say this as a sales advantage: it is what should happen on any well-run job. If someone offers to remove the rubble "for a lump sum" without telling you where it goes or giving you paperwork, be wary.

Can you put rubble in the street bin? No, and this matters: public street containers are for municipal collection and are not meant for building waste. Renovation rubble goes into its own hired skip, with a waste carrier behind it.

There is a separate case. If fibre cement sheet or another material that may contain asbestos turns up during demolition, that task is stopped and handled differently, with a specialist company. Do not mix it with the rest or take it out in bags yourself.

Price of rubble removal per m³ and how it appears in the quote

Rubble removal is priced per cubic metre, and the price list gives 28 €/m³ at functional quality, 41 €/m³ at mid-range and 65 €/m³ at high-end. Guide prices · VAT not included. This is not a binding offer: the fixed price comes after the free technical visit.

Bear in mind that this reference comes from few jobs, only two, and does not amount to a skip hire rate by size. In fact we give no specific skip price because we have no verified data to support one. What you can do is ask the waste carrier or the company how many m³ they estimate and what each one costs.

To see how it fits, we use the scenario of the 3 m long partition wall (7.5 m²) knocked down and repaired. The figures come from items in the price list, base without VAT:

ItemFunctionalMid-rangeHigh-end
Partition demolition (lump sum)80 €184 €503 €
Rubble (1 m³)28 €41 €65 €
Total for the full scenario, with assistance work, flooring, levelling and painting1,030 €1,422 €2,062 €

Guide prices · VAT not included. Not a binding offer; the fixed price comes after the technical visit.

The reading is simple: the rubble from a partition weighs little in the total. What makes a job more expensive is not removing a cubic metre, but the work that the demolition creates and the repair of what is left. That is why we distrust quotes that put "rubble" down as a round sum without saying how many m³ they estimate.

Is removal included in a renovation quote? It should be, as its own item or within the demolition one, but do not take it for granted. Check that it states what it includes: loading, transport, waste carrier and receipt. If it only says "clearance", ask what it covers. And if there is no waste line anywhere, the cost is hidden in another item or will arrive later.

If a quote comes in far below the others, look at what it says about installations, waterproofing and site management. Rubble removal is also often one of the items where corners are cut, and it is one of those that cause most trouble later.

Frequently asked questions about rubble and skips in a renovation

How much rubble does knocking down a partition wall produce?

A non-structural partition wall 3 m long by 2.5 m high (7.5 m²) leaves around 1 m³ of rubble once broken and bulked. In the wall it took up considerably less, but loose pieces leave gaps and the real volume is greater.

What is rubble bulking?

It is the increase in volume a material undergoes when it is broken up. In the wall it is a compact block; in the skip it is fragments with air between them and it takes up more room. That is why rubble is always counted already bulked, which is what is loaded and what is charged.

Do you need a permit to put a skip on the street?

Normally you have to ask the town hall for authorisation to occupy the public highway, but the conditions, fees and deadlines depend on each municipality. It is a different procedure from the works permit. Confirm it with your town hall before hiring the skip and put in writing who handles it.

What receipt should I keep for rubble removal?

The document issued by the authorised construction waste carrier when it receives the material. It should show who delivers, which waste carrier receives it and which job it comes from. Ask for it when the works finish and keep it yourself, not only the renovation company, in case a complaint or inspection arises.

Can I put rubble in the street bin?

No. Public street containers are for municipal collection and do not accept building waste. Renovation rubble must go into a skip hired for that purpose and be removed by an authorised waste carrier, who will give you the corresponding receipt.

Keep reading

✆ Call✦ WhatsAppGet a quote →