Full renovations

What is a Catalan-style flat roof? Full guide to the ventilated terrace

By the Tu Nuevo Piso teamPublished 11 July 20269 min read

If you live in Barcelona or elsewhere in Catalonia, you have probably climbed onto the roof of an old building at some point and noticed the distinctive floor of reddish terracotta tiles. It is a space that is part of the Mediterranean spirit, a special corner where the washing dries in the sun and neighbours meet at dusk. But behind its apparent simplicity is a masterpiece of traditional thermal engineering known as the Catalan-style flat roof. This walkable flat roof is not just decorative. It is a remarkably advanced passive technology that has been protecting buildings from the summer heat for decades. When we are looking for sustainable building solutions, the past shows us how local know-how already solved thermal insulation without using any energy. If you are planning to renovate an old building in Barcelona, you will almost certainly come across this type of ventilated roof.

Key points to remember

Here is a summary of the essentials about the Catalan terrado before we go into detail:
  • Ventilated chamber: Its secret is a continuous flow of air under the ceramic tiles, which reduces the solar heat reaching the building.
  • Walkable: It allows full foot traffic, ideal for a shared terrace or leisure use.
  • No condensation: As water vapour is ventilated away, it naturally prevents damp inside the home.
  • Step up: The physical chamber raises the outdoor floor above the level of the interior.
  • Ideal for renovations: When planning a terrace and balcony renovation in Barcelona, this traditional design still stands out for its durability.

The historical origins of terrados in Barcelona's grand buildings

This construction technique is very characteristic of the grand bourgeois buildings (fincas regias) of Barcelona, built at the end of the nineteenth century. During the development of the Cerdà Plan in the Eixample, architects had to deal with the elements in a humid Mediterranean climate with intense summers. Pitched roofs with Nordic-style tiles did not allow the roof to be used by residents. So Catalan ingenuity refined the traditional flat terrados. But it was not only a space for hanging out washing or airing the flats. The introduction of a lower air chamber was a pioneering way to insulate the rooms below from the Mediterranean summer heat. Thanks to high-quality local clay and the skill of the master bricklayers, who could lay small brick partitions (tabiquillos conejeros) quickly and precisely, this passive bioclimatic system was born and is still fully working more than a century later.

How does this passive thermodynamic system work in practice?

The physics behind the Catalan roof is incredibly simple but very effective. It is based on the basic principle of air convection. When the sun hits the red tiles on the outside, they heat up a lot. On ordinary flat roofs the heat would pass straight through to the slab, warming the flat below and increasing energy use. In the Catalan roof, however, the heat does not enter directly. A continuous air chamber of about 20 centimetres under the floor acts as a shield. The air inside the chamber warms in the sun, becomes less dense and naturally rises, looking for the perimeter vents to escape outside. As it leaves, it creates a suction that draws fresh air in through the openings at the other end of the terrace. This unbroken cycle creates a current of air under your feet that carries away the heat in the roof, stopping it from reaching the building's slab and lowering the indoor temperature without using any electricity.

The construction anatomy: layers and materials step by step

To ensure ventilation and watertightness, several specific layers must be laid with care. Below is the traditional construction section, from the bottom up:

  • Base slab: The structural slab of the building, which carries all the weight.
  • Rigid or flexible waterproofing: Once bitumen felts, today elastic membranes that prevent damp.
  • Small brick partitions (tabiquillos palomeros): Simple hollow-brick walls built in parallel every metre, with openings that let air flow across.
  • Double layer of thin ceramic tiles (rasillas): A first layer of ceramic tiles laid edge to edge sits on the partitions. Directly on top, a second staggered layer of tiles is fixed with mortar, for mechanical strength.
  • Compression screed: A cement mortar that levels the surface and creates the fall needed (between 1% and 2%) to direct rainwater away.
  • Final paving: Traditional Catalan floor tiles (baldosín catalán) fixed with suitable mortar to withstand foot traffic and the weather.

Pros and cons: why it is still relevant today

Despite modern high-tech insulation, the traditional terrado is still highly valued by architects across the Barcelona metropolitan area. Its big advantage is excellent thermal inertia in summer. It does not rely only on synthetic blankets and panels, which can degrade over the decades, so it offers a very durable passive performance, stable under harsh solar cycles. Its maintenance is also straightforward. In fact, it is easy to inspect as part of the building inspection (ITE) in Barcelona, and damp is detected much more quickly than on an inverted roof with gravel. But it has clear weaknesses too. Building it is very labour-intensive and requires specialist bricklayers to raise the small partitions one by one, evenly, which increases the final cost of the works. It also adds significant weight to the building's load-bearing structure, which is a problem if you plan to work on weakened timber floors.

Comparison table: the Catalan roof against other options

Here is a simple comparison to help you assess the usual roof options in building work:

Technical aspectCatalan-style roofInverted roofGravel roofRaised paving on pedestals
Thermal behaviourPassive, through convective air flow. Ideal in a warm Mediterranean climate.Direct insulation (XPS) on a waterproof membrane. Avoids direct thermal bridges.Mass effect from heavy gravel over insulation. High heat retention, which is bad in summer.Open chamber under raised tiles, but without thermal containment partitions.
WalkabilityFully suitable for the everyday traffic of the owners' community.Walkable with floor or ceramic tiles over the protective insulation.Not walkable (limited to periodic maintenance tasks).Very walkable. Floating tiles create modern, flat surfaces without steps.
Thickness and weightHigh thickness (about 35 cm) and substantial weight, which requires a strong slab.Medium thickness (about 18 cm) with a fairly light and balanced weight.Low thickness, but the gravel places a notable static load on the slab.Thickness varies with the pedestals, but the structural weight is very light.
Difficulty of repairComplex if the fault is structural, as the ceramic layer has to be lifted.Simple, as the XPS boards are easy to remove to look for leaks.Simple; just remove the gravel locally to replace the broken membrane.Excellent. The removable tiles can be lifted by hand in seconds if there is a leak.
CTE regulationsRequires additional insulation in the slab under the Technical Building Code (CTE).Complies fully by adjusting the thickness of the XPS insulation built into the roof.Suitable only for inaccessible areas where aesthetic requirements are secondary.Complies by installing insulating panels under the modern PVC pedestals.

Common faults and why they matter in renovations of older buildings

Over the years, these traditional roofs can develop common faults. The main problem is the complete absence of elastic expansion joints in the layer. When the roof absorbs extreme heat and cold, the mortar and tiles move violently. If the perimeter layer pushes directly against the small walls, this force can crack them and shift the masonry, requiring urgent façade renovation in Barcelona. Another typical fault is dirt and nests building up in the perimeter ventilation grilles. If these get blocked, air stops flowing, the thermal effect is lost and unwanted condensation appears in the flats below. When carrying out any renovation, it is essential that all these technical changes and construction layers are recorded in detail in the Building Logbook (Libro del Edificio), so that the building can be properly maintained over the long term.

What is a Catalan roof, in one sentence?

If you are wondering what a Catalan roof is (many people search for it without the "a la"), the short answer is this: a Catalan roof is a flat, ventilated roof with an air chamber between the ceiling and the terrace floor, which insulates passively against the heat. Everything else in this guide, including the layers, the advantages and the faults, expands on exactly that.

The "Catalan terrace": the same system, seen from above

If you came looking for Catalan terrace or terrace in the Catalan style, you are asking about the same thing. When the Catalan-style roof is walkable, the ventilated terrado becomes the traditional terrace of Barcelona, the place for hanging out washing, setting out plant pots and, once renovated well, gaining an outdoor room. The ventilated chamber keeps working underneath in exactly the same way. Only the use changes.

If yours is worn out (broken tiles, puddles, leaks), it can be restored without losing the system. We cover this in our flat roof renovation and terrace renovation services.

Frequently asked questions about the Catalan-style flat roof

Here we answer the most common questions about this remarkable and efficient roofing system:

What is the main difference between a Catalan-style roof and an inverted roof?

The key difference is the ventilated air chamber. In a Catalan roof, air flows freely under the floor thanks to the small brick partitions, which regulates the temperature naturally. In an inverted roof, the thermal insulation sits directly on the waterproofing with no ventilated chamber in between, and relies entirely on the density of the synthetic insulation boards. So the Catalan roof handles the direct heat shock in a more natural way.

Why does a Catalan roof usually have a step up to access it?

It is because of the thickness of the system. To accommodate the base slab, the air chamber created by the partitions (about 15 to 30 cm), the double layer of tiles, the mortar and the final floor tiles, a considerable height is needed. As a result, the terrace level sits above the internal floor level of the home, so you have to step up when you go out onto the roof.

Is a vapour barrier needed on a Catalan-style roof?

Not in the traditional way. The micro-ventilated air chamber is precisely what prevents moisture from building up through condensation from inside the building. Because the air in the chamber is constantly renewed, the water vapour never condenses on the underside of the floor, which makes a sealed vapour barrier unnecessary.

Does this type of roof need a lot of maintenance?

Yes, mainly in terms of cleaning the perimeter ventilation grilles and checking the joints. If the openings that let air into the chamber get blocked by dirt or bird nests, the system loses its thermodynamic effectiveness. Cracks and leaks that could damage the intermediate screed should also be watched for.

Is a Catalan-style roof compatible with modern insulation?

Absolutely. In current renovations in Catalonia, a mineral wool or fibreglass blanket is often added inside the chamber, directly above the structural slab. This combines the benefits of direct thermal insulation with the airflow of the traditional chamber, achieving thermal transmittance values that comfortably meet the 2026 energy regulations. You can also apply for Next Generation grants in Catalonia to help fund better thermal performance on these roofs.

Keep reading

✆ Call✦ WhatsAppGet a quote →